/target pet

[stroudja]

[Samanna]

[stroudja]

[Grokii]

[blue]

Is there a version of this panther macro, but for group members? I've been trying to set one up, like the following:

/target [groupmember]
/pause 45, /cast [#]
/pause 5, /target [another groupmember]
/pause 45, /cast [#]

Problem is, it won't target Line 1's groupmember, gives the "no one around here by that name" or "can't see that person" ... can't remember exactly ... error message, and does the remaining /target on line 3 fine.

I've searched the boards for panther macros, but none seem to address targetting group members, other than if I manually F-target them myself first.

Thanks for reading

[Grokii]

The problem with your macro is not giving a delay between targeting command and the start of the cast command. Change your first line to have a pause like your fourth line and it should work better. I like to cast on 6 people instead of 4. Only problem is that it takes a little pretargeting on your part, but I don't have a problem with it:

I have two buttons called 'proc' and 'proc2'.

proc:
/pause 50, /cast 6
/pause 5, /target XXXPLAYER2XXX
/pause 50, /cast 6
/pause 5, /target XXXPLAYER3XXX
/cast 6


proc2:
/pause 50, /cast 6
/pause 5, /target XXXPLAYER5XXX
/pause 50, /cast 6
/pause 5, /target XXXPLAYER6XXX
/cast 6

And remember you can use /pet target... and that can be one of your target commands instead of having to type the name of your summoned pet all the time.

[Ungkor]

[Grokii]

[blue]